By: TFSP On: February 22, 2018 In: Article Comments: 0

Everyone likes saving some money wherever they may pitch in for reducing the cost of labour when it is about renovation of the house. For an average house, handyman there’s much more involved than they’re usually aware of while attempting Floor Sanding Melbourne and polishing of timber floor in their house.

There’re various factors that may lead to unsatisfactory and poor quality finishes which in a lot of cases would be revealed only when the coats have been applied and task has been accomplished.

Any kind of imperfections in the whole process of efficient Floor Sanding Melbourne would be highlighted by applied coats along with reflected light. One of the common imperfections is stop marks where machines have been left stationary while sanding the floor. It’s a very common mistake which most of the unskilled operator makes. The amount of damage the imperfections may cause would depend mainly on depth of stop marks and in a few cases it could be extreme.

Groove and tongue Timber Floor Sanding Melbourne is usually 19mm thick, even though there are just 4 to 5 mm timber above actual groove and tongue itself. This is the amount that you may work with safely while attempting to bring the floor to one level.

Two of the best tips are:

  1. Make very straight runs of machines through the way unto the walls and the way back making sure there are no restrictions
  2. Start with coarse sand paper for flattening the floor before actually moving to finer grade paper

Amongst the other imperfections of sanding which are common are chatter marks. These marks maybe seen in the reflected lights as fine corrugating throughout the whole floor and they are usually caused by vibrations in the machine. These imperfections are much more to be done with quality of machines which are available to be hired.

The industrial Floor Sanding Melbourne machines used by the professionals aren’t available to be hired. One good way of minimising or eradicating the chatter marks is rotary sand the flooring as the final sand with the help of 100 grit and 150 grit of paper.

Even though there are various imperfections in Timber Floor Sanding Melbourne which are possible and may contribute to poor finishes, sanding is just one single component of this work.

The foreign materials including the atmospheric dust in the top coats are also quite common issue for DIY handymen. The extremely meticulous cleaning of the flooring before the coating and between the coats needs to be carried properly as the floor polyurethane often tends to mound the fine dust mites accentuating them once viewed in the reflected light once coat has been dried.

Conclusion

The fact is that when the Timber Floor Sanding Melbourne is done properly, it may be the most prominent feature of the interior of your house. On the basis of the level of the natural light which is present there, poorly sanded flooring would become an eye sore.